Hello,
I created couple of formulas in the report and am using them as the group level (GL) 1 and 2. My data is not consistent as such not all Group level 1 have group level 2. Only few of group level 1 have group level 2. Hence when a group level 2 does not exist I give a value of “NA”. I report i get now is as below
GL1-A
NA
Details
GL1-C
GL2-C1
Details
This is a drill down report and I want to design it in such a way that when I click on GL1-A the report should drill down to Details and not show be the dummy group “NA”. But with GL1-C it should drill down show sub group GL2-C1 and then further drill down to details. Can I do this in Crystal 2008?
So basically drill down group level 1 for GL1-A should be Details, while Drill down group level 2 should be details for GL3-C.
I hope my question makes sense. Any answers are appreciated.
Thanks
Vatsa
vatsahs (BOB member since 2007-12-05)