BO column headers issue

Hello everyone
Whenever I drag a dimension from Report manager to the actual report, the dimension data values who up allright- but the header information is missing i.e. I have to physically label the column headers.
Is this a bug with BO version 6.0 ?
Thanks
~Rohit


Rohit :india: (BOB member since 2004-03-23)

Iā€™ve seen this happen.

Drag it in twice that usually solves it.

Also, what actual version are you on? 6.0 is not a good place to be.


Steve Krandel :us: (BOB member since 2002-06-25)

HI Steve
I am haivng the same problem after migrating to 61b also.
I have tried dragging it twice- it either createds the same column twice or overwrites the neighboring column.
~Rohit


Rohit :india: (BOB member since 2004-03-23)

Steve,
An update on the previous post -
I have a cross tab in BO. While testing it ā€¦users drag out certain columns and drag them back in .

When they do drag them back in; we have the issue of blank headers.Also ā€˜Show Variable headerā€™ & ā€˜Bo version 3.x corsstabā€™ options are enabled.


Rohit :india: (BOB member since 2004-03-23)

Remove the BO 3.x stuff. Not sure what else is going on.


Steve Krandel :us: (BOB member since 2002-06-25)

Chances are that a ā€œCustomā€ Header was created at one time. Custom headers do not follow the data around, so that could be your issue. Iā€™d remove the headers (unchecking the box) and then adding it back again.

Your headers should read along the lines of: =NameOf()

If it does not, then that was definitely the issue.


digpen :us: (BOB member since 2002-08-15)